Replacement OBD2 Cable for INNOVA 3100 3110 3120 3130 3130C 3140 3150 3160

If your INNOVA code reader has started dropping the connection mid-diagnosis, the problem is often the main cable, not the scanner. The original cords that shipped with models like the 3100, 3110, 3120, 3130, and 3130C stiffen, crack, and corrode at the pins after years of garage use, and a failing cord shows up as intermittent no-communication errors just when you need a clear read. Replacing the cable is the practical fix that keeps a proven tool in service.This JUTA main cable runs between your vehicle's 16-pin OBD-II port and your scanner's 25-pin DB25 connector. One end is a 16-Pin male OBD-II connector that plugs into the diagnostic port under your dash; the other is a 25-Pin male connector built for INNOVA DB25 scan tools. Both connectors are designed to seat firmly, so the link holds steady while you read codes, clear the check engine light, or run I/M readiness checks before an inspection.At 5.1 ft / 155 cm, the cable gives you real working slack. Many vehicles keep the OBD-II port tucked behind the steering column or under the dash trim, and a short cable pulls tight and strains the connectors on both ends. With extra length, the scanner can rest on the seat or workbench at a comfortable angle, and the cable routes cleanly without bending sharply around panels, pedals, or seat tracks.For anyone who runs diagnostics every week, a dependable connection matters more than any other feature. A loose fit or worn pins produce intermittent errors that are easy to mistake for a scanner problem, sending you down the wrong troubleshooting path. Swapping in a fresh cable restores a steady link for reading codes, watching live data, and checking emissions readiness, and keeping a spare in the kit means a dead cord never stops a diagnostic session.Before ordering, confirm your scanner model against the compatibility list on this page. This cable is a direct replacement for the main cable that came with your INNOVA code reader; it is not a generic universal DB25 cord. Both ends plug in with no extra parts and no setup, so you can get back to scanning the same day it arrives.

• Compatible With: INNOVA 3100, 3110, 3120, 3130, 3130C, 3140, 3150, 3160, 31703, 31603, 31403, 5610 DB25 OBD2 scan tools. Check your scanner model against the list before ordering.
• One end is a 16-Pin male OBD-II connector that plugs into your vehicle's port; the other is a 25-Pin male connector built for INNOVA DB25 scan tools. Both seat firmly, so the link stays steady while you read codes.
• Direct replacement for the cord that came with your INNOVA scanner. If the original has turned stiff, cracked, or corroded and the connection keeps dropping, swap this in and it works like the original did.
• The 5.1 ft / 155 cm cable gives real slack when the OBD-II port sits tight under the dash or behind trim. Rest the scanner on the seat or workbench at a comfortable angle instead of holding it near the port.
• Built for weekly garage use. The connectors hold their fit through repeated plugging and unplugging, giving you a dependable link for reading codes, clearing the check engine light, and running I/M readiness checks.
• A working spare to keep in the kit. Replacing a worn main cable keeps the INNOVA scanner you already own in service, instead of retiring the whole tool over a failing cord.